Quickdata Quikstop-15 Instruções de Operação descarregar pdf (Página 22)

Subject to change without notice

Owner Manual

Operating Instructions

2.1A-30004-A02

Page 22 of 36

LINCOLN GmbH & Co. KG  Postfach 1263  D-69183 Walldorf  Tel +49 (6227) 33-0  Fax +49 (6227) 33-259

Operational Test/ Triggering an Additional Lube Cycle

 To check the pump operation it is possible to perform an

additional test. Refer to Trigger additional lubrication

below Display window of the membrane key pad.

Tests

Replace the pump element

* Remove the pressure relief valve from the pump element.

* Unscrew the pump element. Take care that the piston,

the pull-back spring and the washer are not left lying in

the grease, otherwise the reservoir must be

disassembled in order to remove these pieces.

Important: Do not leave the piston, spring and washer in the

housing because they may block the motor.

* Install a new pump element and a new sealing ring.

Make sure that only one sealing ring is installed below

the pump element.

Note: Pump element with adjustable lubricant output must

be set to the corresponding output.

Fig. 38 - Replacing the pump element

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sem comentários

Quickdata Quikstop-15 Instruções de Operação Página 22